SCM SIGMA 65 beam saw

SCM SIGMA 65 BEAM SAW with Dust Collection and front lift table

MAKE OFFER!!

This panel saw was manufactured in April 2001, has a new control, and a new PLC. All parts are factory authorized and purchased through SCM parts. A new carriage drive chain was installed about 2 years ago. This saw has run an average of about 1 hour per day. Runs like new.  Comes complete with KUFU Seco 10Hp dust collector.  Kufu motor have been recently serviced and had bearings replaced.  Lift table has 4000 lbs lift capacity.  This is the cleanest Sigma 65 you will ever see on the used market.

TECHNICAL SPECIFICATIONS

Main motor 10hp
Cut length 10’ 6”
Cut height 2.25”
230 – 440 v 60 hz
3 5ft. air tables / one with fixed fence.
6 gripper clamps that are adjustable
2 carriage feed speeds
Full rear protection wall.
THK guides on rise and fall of blades
Side alignment
“Cutty” on board optimization software
3 sets of blades
One 4,000lb lift table on the front included

Collections: BEAM SAWS, PRE-OWNED MACHINES

Category: BEAM SAWS, PRE-OWNED, USED BEAM SAWS

Type: BEAM SAWS